Справочник Пользователя для iLuv i1055

www.i-Luv.com

  

12

 

Follow the illustrations below to make your player stand. 
 

 

 
Pull out the STAND at the back of the unit gently. Then, carefully stand the unit. 
 

The battery is pre-installed in the remote control with the insulation plate. Before starting to 
operate the remote control, please pull out the insulation plate from the battery compartment. 
 

If the remote control does not work or the signal gets weaker, the 
battery might weaken. In that case, please replace the battery. 
1. 

Pull out the battery holder as shown right. 

2. 

Place one battery (CR 2025) as shown right. Make sure that 
the polarity (+/–) of battery matches the marks inside the unit. 

3. 

Insert the battery holder into its compartment as shown right. 

 

 Do not attempt to recharge, short-circuit, disassemble, heat or throw the batteries into a 

fire. 
 

1. 

Insert the DC plug at the end of the adapter cord into 
the DC IN jack at the top side of the player.  

2. 

Plug the other end into an AC wall outlet. 

  

 Only use with the supplied AC adapter. Using with 

another AC adapter could cause damage. Remove both the 
DC plug and AC plug to disconnect the AC adapter when not necessary.