Справочник Пользователя для HP CD-9400

14

While the CD changer is playing, you can program a
sequence of tracks, but not an entire CD. Press 

during play, then select the CD and track using the remote
control’s number buttons and 

DISC SET/TRACK SET, 

and

press 

PGM. 

When the current track finishes playing or you

press 

3, programmed play starts.

Or, you can store the track currently being played directly
into memory. While the track is playing, press 

PGM 

once

to enter the program mode, then press 

PGM 

again to store

the current track. You might find this feature convenient
to use along with hi-lite scan.

In the program mode (when 

 appears on the display),

press 

CLEAR 

to erase the last-stored selection (track or

CD). The new last-stored selection appears on the display
until you press 

6 (or 3 on the remote control).

Note: You cannot erase a selection that is currently
playing or that has already played.

Turning off the CD changer does not clear the
programmed sequence. To clear the sequence, do any of
the following:

•

Press 

7 when the CD is stopped.

•

Start best selection play.

•

Select 

, 

, 

, previous scan,

or play the CD in the single play slot while
programming a sequence.

•

Press 

RANDOM 

while programming a sequence.

When you record a programmed sequence onto a cassette
tape, you can program a pause to occur after the last
selection you plan to record on the first side of the tape
(so you can turn the tape over).

To store a pause, press 

8 on the remote in Step 3 of

“Programming a Sequence” on Page 13. 

 appears on the

display.

During play, when the CD changer pauses and displays

6, turn over the tape and press 8 to resume recording.

Notes:

•   You cannot program a pause as the first or last selection.
•   You cannot program two pauses in a row.