Справочник Пользователя для Bil-Jax Personal Lift Cougar Lift Electric Hydraulic Lift Platform

XLT-1571AC

3-2

Upper Control Box

The upper control box is located on the back of the top mast and is accessible from the
platform. The upper control box contains 3 controls,

DOWN

selector switch,

EMERGENCY STOP

pushbutton, and

pushbutton. The controls on the upper control box

are used to raise and lower the unit. Refer to Figure 3-2.

UP/DOWN

SELECTOR

SWITCH

EMERGENCY

STOP

PUSHBUTTON

Figure 3-2. Upper Control Box

3-2 NORMAL OPERATING PROCEDURE

Perform the following procedures to operate the Cougar Lift.

1. Read and follow all safety precautions contained in Section 1 and all responsi-

bilities outlined in the ANSI A92.3 reprint contained in Section 7 of this man-
ual.

2. Position the lift at the work area. Make sure the lift is on a firm and level surface

and that there are no potential hazards such as overhead obstructions or electri-
cally charged conductors. Do not operate the lift if such hazards exist.

3. Check the lift for damaged or worn parts and repair or replace as necessary.

4. Check to be sure that the platform is properly attached to the lift.

5. Raise the casters located under the platform by depressing the

WHEEL UP

BASE

SET

pushbutton located on the lower control box. Raising the casters allows the

base to set firmly on the two foot pads.

6. The lift should be level and positioned on the two foot pads with the

WHEEL

BASE SET

pushbutton lit green. Ensure that the platform's upward path of

travel is free from obstructions. Reposition the lift if necessary.

NOTE:

The lift is equipped with a level sensor that will prevent the lift from rais-

ing if the lift is at a slope greater than 1 degree. The green

WHEEL

BASE SET

pushbutton will no longer illuminate until the lift is re-

leveled.

7. Enter the platform. Ensure that both side midrails are positioned properly.