Справочник Пользователя для Bil-Jax Personal Lift Cougar Lift Electric Hydraulic Lift Platform

Annually check for wear on the slide blocks and replace or retighten as necessary. If the 
lift exhibits excessive mast sway, it is probable that the slide blocks need adjustment. The 
slide blocks should be adjusted so that there is no air gap between the slide block and the 
mast the slide block is moving against. There are 12 slide blocks, 6 upper and 6 lower. 
The adjustment procedure is the same for all slide blocks. Three upper slide blocks are 
shown in Figure 4-9.  

1.  Loosen, do not remove, the slotted hex head screw securing the slide block to be 

adjusted. 

2.  Using an allen wrench, turn the set screws in (clockwise). This will push the 

block in against the next mast. Do not overtighten. Tighten the slotted hex head 
screw to secure the slide block in position. 

3.  Check all slide blocks and make adjustments as necessary. 

4.  After all adjustments are made, fully extend the lift. If the platform can be low-

ered without stopping then the blocks are properly adjusted. 

SET

SCREWS

SLOTTED

HEX SCREW

SLIDE

BLOCKS