Справочник Пользователя для M-S Cash Drawer A794
Chapter 6: Programming Information
A794 Owner’s Guide
December 1999
66
Generate Pulse to Open Cash Drawer
ASCII
ESC p n p1 p2
Hexadecimal
1B 70 n p1 p2
Decimal
27 112 n p1 p2
Value of n:
00, 48 (Decimal) = Drawer 1;
01, 49 (Decimal) = Drawer 2
01, 49 (Decimal) = Drawer 2
Value of p1:
0-255
Value of p2:
0-255
Sends a pulse to open the cash drawer.
Formulas
The value for either p1 or p2 is the hexadecimal number multiplied by 2 msec to equal
the total time.
the total time.
♦
On-time = p1 (Hex) x 2 msec
♦
Off-time = p2 (Hex) x 2 msec
Related Information
The off-time is the delay before the printer performs the next operation. Refer to cash
drawer specifications for required on and off-time.
drawer specifications for required on and off-time.
Select Cut Mode and Cut Paper
ASCII
GS V m
GS V m n
Hexadecimal
1D 56 m
1D 56 m n
Decimal
29 86 m
29 86 m n
Value of m:
Selects the mode as shown in the table.
Value of n:
Determines cutting position only if m is 65 or 66.
m
Feed and Cut Mode
0, 48
Full cut (no extra feed).
1, 49
Partial cut (no extra feed).
65
Feeds paper to cutting position + (n times vertical
motion unit), and cuts the paper completely.
motion unit), and cuts the paper completely.
66
Feeds paper to cutting position + (n times vertical
motion unit), and performs a partial cut.
motion unit), and performs a partial cut.
Range of m:
0, 48; 1, 49
65, 66 (when used with n)
65, 66 (when used with n)
Range of n:
0 – 255
Default of m, n:
0
Selects a mode for cutting paper and cuts the paper. There are two formats for this
command, one requiring one parameter m, the other requiring two parameters m and n.
The format is indicated by the parameter m.
command, one requiring one parameter m, the other requiring two parameters m and n.
The format is indicated by the parameter m.
Formulas
n times the vertical motion unit is used to determine the cutting position to which the
paper is fed.
paper is fed.