Листовка для BENDIX BW1742
P N M L K J H
G F E D C B A
MC-12 Controller Cable Assembly
•
D
amaged connectors or wires, caused by dangling or loose wires not properly restrained.
•
Power connection not capable of supplying 12 volts at 3 amps because of a poor connection,
bad crimp.
bad crimp.
•
Corroded connectors and connections not properly sealed or seated.
•
Terminals not completely latched or sealed into connectors; harness connector bolt not tight.
•
Improperly spliced connection repair or repair not sealed properly.
•
Excessive sensor air gap, sensor bushing tension or excessive bearing end play
(Gently push sensor against exciter ring, or readjust bearings).
(Gently push sensor against exciter ring, or readjust bearings).
•
Non functioning antilock components, sensor, controller, modulator.
Additional Servicing Tips
•
Gently probe terminals when checking for resistances, do not deform contacts.
•
Apply nonconductive dielectric grease to any and all connectors if
inspecting or disconnecting connectors.
inspecting or disconnecting connectors.
•
If excessive cable length is present, bundle and tie wrap
neatly to adjacent air lines or framing members.
neatly to adjacent air lines or framing members.
•
Do not pierce wires with probes when
roubleshooting harnesses.
roubleshooting harnesses.
SENSOR 1
SENSOR 2
VOLTAGE
w/STOP
LAMP
POWER
N - P 15 - 2500 Ohms
L - M 15 - 2500 Ohms
ECU
CONTROLLER
Replace Controller
MODULATOR
P N M L K J H
G F E D C B A
P N M L K J H
G F E D C B A
CHECK THE VEHICLE WIRING HARNESS CONNECTOR
FOR THE PROPER RESISTANCE WITH
STOP LAMP POWER OFF
IF THESE LED'S
ARE ILLUMINATED
ALL CONTACT OF THE 14 PIN CONNECTOR ABOVE SHOULD
NOT HAVE ANY CONTINUITY TO THE GROUND CONTACT
"C" CONTACTS "A" & "B" ARE POWER TO THE MC-12.
NOT HAVE ANY CONTINUITY TO THE GROUND CONTACT
"C" CONTACTS "A" & "B" ARE POWER TO THE MC-12.
BW1742 © Honeywell 5/98 Printed in U.S.A
9.5 - 11.5
Ohms
White to White
9.5 - 11.5
Ohms
Black to Black
Status Light
Stop L. Power
Ground
*Constant Power
Stop L. Power
Ground
*Constant Power
To Controller
Vehicle wire harness
A - C 9 to18 Volts DC
ADDITIONAL INFORMATION:
1-800-247-2725
B - C 9 to18 Volts DC
Sensor 2
Sensor 2
Sensor 2
Sensor 1
Sensor 1
Sensor 1
Most Commonly Encountered Problems That Result In LEDs Being Illuminated.
Repair or Replace Components As Necessary
*
Old
Style
New
Style
*Old Style Connectors do not have a Constant Power terminal