Инструкции Для Сборки для West Elm Chunky Wall Shelf

mounting instructions

: chunky wall shelf

NOTE:
•     Stud mounting is recommended wherever possible.
       Use proper hardware for your wall type (such as
       anchors for drywall). When in doubt, consult your
       local hardware store. For your safety, installation by
       two people is recommended.
•     Designed to be used for decorative items only.
•     Maximum load on 2' shelf is 40lbs. stud mounted/10lbs drywall mounted
      Maximum load on 3' shelf is 40lbs. stud mounted/10lbs drywall mounted
      Maximum load on 4' shelf is 50lbs. stud mounted/15lbs drywall mounted
•     Wipe with a soft, dry cloth. To protect the finish, avoid
      the use of all chemicals and household cleaners.

9510975/9510983/9510991- 04/07

page 1 of 1

drywall anchor 3x

screw 3x

! For drywall mounting, use anchors with screws.

For stud mounting, use screws only.

1. This shelf comes with a paper template which can be used to

locate the position of the shelf on your wall and mark the insertion

points of the mounting hardware. The template outline indicates

the line of the shelf edge at the wall. The centerpoints are toward

the top of the shelf and indicate the point of insertion for the

drywall anchors and screws.

2. Temporarily tape the template to the wall with the outline

indicating the desired location of the shelf. Use a carpenter’s level

to make sure the shelf edges are level.

3. Using a pin, poke throught the template into the drywall at the

center points to mark the locations on the wall. Remove the

template.

4. For stud mounting, skip to step 5. For drywall mounting: using a

philip's head screwdriver, insert the drywall anchors (A) into the wall

at the insertion points. Turn clockwise until anchors are flush with

the wall.

5. Insert screws (B) into the anchors or directly into studs at the

insertion points, leaving approximately 1/2" between the back of

the screw head and the wall.

6. Align keyhole notches on the back of the shelf over the screw

heads and slide the shelf down until it rests on the screws. Tighten

or loosen screws as needed to fit the shelf snugly against the wall.

template outline

center points

top