Инструкция С Настройками для Weber 475

BUILT-IN CONSTRUCTION GENERAL INFORMATION

WARNING

A Weber-Stephen Products Co. insulated

s l e eve must be used for any bu i l t - i n
installation.

CLEARANCE FROM COMBUSTIBLE SURFACES OR
STRUCTURES

Warning: Clearance from the outside walls of the
sides and back of the insulated sleeve must be a
minimum of 24 inches from a combustible surface.
Measure from the outside wall of the insulated
surface to the combustible surface. Figure 2. Refer
to “Install Gas Supply” on page 2 before starting
installation.

Figure 2

Figure 1

LOCATING YOUR BARBECUE

When determining a suitable location for your barbecue
installation, give attention to concerns such as exposure
to wind, proximity to traffic paths, and keeping any gas
supply lines as short as possible. Never locate the Weber
Gas Barbecue in a garage, breezeway, shed, under an
unprotected overhang, or other enclosed area. Locate the
barbecue and structure so there is enough room to safely
evacuate the area in case of a fire.

CLEARANCE FROM NON-COMBUSTIBLE SURFACES
OR STRUCTURES

Warning: Clearance from the outside walls of the
sides and back of the insulated sleeve must be a
minimum of 6 inches from a non-combustible surface.
Measure from the outside wall of the insulated
surface to the non-combustible surface . Figure 1.
Refer to “Install Gas Supply” on page 2 before
starting installation.

COMBUSTIBLE SURFACE

24 inches

NON- COMBUSTIBLE SURFACE

6 inches

WARNING: All countertop finished surfaces must be
constructed of a noncombustible material.

Countertop

Insulated sleeve