Справочник Пользователя для Whistler TOTAL BAND PROTECTION XTR-695

Mounting Guidelines

• Mount the unit as low as possible near the 

center of the windshield.  

• Do not mount the unit behind wipers, 

ornaments, mirrored sunscreens, etc. These 
obstructions have metal surfaces which can 
affect radar and laser signals and reduce 
critical warning time. (Regular tinted glass 
does not affect reception).

• Some windshields have an Instaclear

™

or 

Electriclear

™

type coating, which affect radar 

signals. Consult your dealer or the owner’s 
manual supplied with your vehicle to determine 
if your windshield has this coating.

• Avoid placing the unit in direct contact with the 

windshield.

• To reduce the possibility of theft, conceal your

unit when not in use.

IIM

MP

PO

OR

RT

TA

AN

NT

T: Make sure the unit is level

Windshield Mounting

• Install the two suction cups and rubber bumper 

onto the bracket by fitting them into their holes.

• Press the suction cups onto the windshield at the 

location you have chosen.

Important: Some newer cars have a plastic safety 
coating on the inside of the windshield. The wind-
shield bracket may leave permanent marks on this
type of surface. To find out if your vehicle has this
type of windshield, check the owner’s manual or ask
your dealer. We recommend that you do not leave
the suction cup bracket on the window in direct sun-
light. If the detector is removed, this may cause
blistering of the dash in some vehicles.
• Slide the detector onto the bracket until it locks into 

place.

• If necessary, the unit may be leveled by bending the

windshield bracket. Press the bracket release button
and remove the detector before bending.

Power Cord Connection

• Plug the small end of the power cord into the 

unit’s power jack.

• Plug the large end into the vehicle’s cigarette lighter.

N

No

otte

e:: Cord fits tightly into detector. When

Fuse Replacement

The lighter socket plug is equipped with a
replaceable 2 amp 3AG fuse located behind the
silver tip. To replace the fuse, carefully unscrew
the tip of the plug.
IIm

mp

po

orrtta

an

ntt:: Unscrew slowly. The tip contains a

spring which may fly out when disassembling.
Insert the new fuse with the spring and screw on
the tip. With use, screw cap on plug may loosen.
Retighten occasionally.

Windshield
Mounting

Rubber Bumper

Power On, Self Test

To turn the Power ON or OFF, push the center

of the Power/Volume button.
Each time your Whistler detector is turned on,

an automatic self-test sequence confirms that

the speaker and visual displays are functional.

• Display shows in order: 
1. WHISTLER 2. X-band 3. K-band 4. Ka-band
5. LASER ON   6.. SR OFF    7. VOICE ON   8. POP
ON 9. B SVR ON 10. FILTER 11. COMBO 12. HIGH-
WAY

Teach/Tutorial Mode

Provides simulated alerts for each type of signal.

• Press City and Quiet buttons simultaneously
• Display Shows: 
• Press Dark button to exit.

Setting Saver

Setting Saver saves your personalized settings
so that when the detector is turned off and then
on again, you do not have to re-enter them.

Feature Engaged Confirmation

Each time a button is pressed, one beep confirms
feature “on”, two beeps confirm feature “off”.

Integrated Real Voice

®

When selected, Real Voice

®

will be used to articu-

late the following:

1. Band Identification
2. Safety Warning System messages
3. Feature Selection

Note: In certain cases the voice message does not

replicate the text message.