Справочник Пользователя для Bunn Beverage Dispenser DV

7

Faceplate Removal - H5 ELEMENT: After removing 

top cover, remove the two upper screws securing the 

faceplate. Carefully lift faceplate straight up until the 

three lower screws clear the key holes.

The check valve, electronic control assembly, safety 

overflow switch, solenoid valve, overflow tube tempera-

ture sensor and terminal block are located at the rear of 

the dispenser. Access is gained by removing the upper 

and lower rear panels. The upper is attached with six 

8-32 slotted-head screws. The lower is attached with 

four 8-32 slotted-head screws. The middle panel must 

not be removed from the dispenser.

P1770.30

42311 022311

  

The check valve, electronic control assembly, over-

flow protection switch, solenoid valve, overflow tube 

temperature sensor, triac assembly (EARLY MODELS 

ONLY) and terminal block  are located on the side of 

the dispenser. Access is gained by removing the side 

panel. The panel is attached with eight 8-32 slotted-

head screws. 

P878.30

WARNING – Disconnect the dispenser from the power source before the removal of any panel or the replacement 

of any component. WARNING - Inspection, testing, and repair of electrical equipment should be performed only 

by qualified service personnel. Disconnect the dispenser fromthe power source when servicing, except when 

electrical tests are required and the test procedure specifically states to connect the dispenser to the power source.