Справочник Пользователя для ICOM AT-140
4
2
INSTALLATIONS
■
PL-259 connector
q
Slide the coupling ring over the coaxial cable. Strip
the cable jacket and pull back to reveal 10 mm of
braid.
the cable jacket and pull back to reveal 10 mm of
braid.
• Soft solder the exposed braid and then pull out the jacket.
w
Strip the cable as shown below. Soft solder the cen-
ter conductor the entire length of the exposed braid.
ter conductor the entire length of the exposed braid.
e
Slide the connector body over the cable and sol-
der as shown below.
der as shown below.
r
Screw the coupling ring onto the connector body.
Solder
Solder
1–2 mm
10 mm
soft solder
10 mm
3
⁄
8
inches
Coupling
30 mm
10 mm (soft solder)
■
Mounting
Attach the AT-140 either horizontally or vertically with
one of the water drains facing downwards. After
mounting, remove the screw in the water drain.
one of the water drains facing downwards. After
mounting, remove the screw in the water drain.
Mounting on a Mast/Metal pole
Mounting on a flat surface
Nut
Spring
washer
Flat
washer(L)
washer
Flat
washer(L)
Flat
washer(L)
washer(L)
Hex head
bolt
bolt
Drill a hole here
Diameter:7–8 mm;
Diameter:7–8 mm;
9
⁄
32
–
5
⁄
16
inches
Weatherproof cap
Flat
washer(S)
washer(S)
Using self-tapping
screws
screws
Using nuts and bolts
WARNING:
Mount the AT-140 securely with the
supplied nuts and bolts. Otherwise, vibrations and
shocks due to waves, etc. could loosen the antenna
tuner making if fall, causing personal injury.
shocks due to waves, etc. could loosen the antenna
tuner making if fall, causing personal injury.
Using U-bolts
U-bolt
U-bolt plate
Flat washer(L)
Spring washer
Nut
Mast/
Metal pole
Metal pole
Flat washer(S)