Инструкции Пользователя для Biostar NF4UL-A9
NF4 Ultra-A9
18
Close C MOS Heade r: JC MOS1
By placing the jumper on pin2-3, it allows user to restore the BIOS safe
setting and the CMOS data, please carefully follow the procedures to
avoid damaging the motherboard.
setting and the CMOS data, please carefully follow the procedures to
avoid damaging the motherboard.
JCMOS1 Assignment
1
3
Pin 1-2 close
Normal Operation (Def ault).
1
3
Pin 2-3 close
Clear CMOS data.
※ Clear CMOS Procedures:
1.
Remove AC power line.
2.
Set the jumper to “Pin 2-3 close”.
3.
Wait for five seconds.
4.
Set the jumper to “Pin 1-2 close”.
5.
Power on the AC.
6.
Reset your desired password or clear the CMOS data.
Case O pen He ade r: JC I1
This connector allows sy stem to monitor PC case open status. If the
signal has been triggered, it will record to the CMOS and show the
message on next boot-up.
signal has been triggered, it will record to the CMOS and show the
message on next boot-up.
Pin Assignment
1
Case open signal
1
2
JCI1
2 Ground
Se rial ATA C onne ctor: JSATA1~JSATA4
The motherboard has a SATA Controller in nForce4 (CK8-04) with 4
channels SATA interface, it satisfies the SATA 1.0 spec and with transfer
rate of 1.5Gb/s.
channels SATA interface, it satisfies the SATA 1.0 spec and with transfer
rate of 1.5Gb/s.
Pin Assignment Pin Assignment
1 Ground
2 TX+
3 TX-
4 Ground
5 RX-
6 RX+
1
4
7
7 Ground