Инструкции Пользователя для Brother 3034D
SEWING AN EMBROIDERING PATTERN
134
f
Apply a thin layer of adhesive or spray
adhesive to the back of the appliqué piece,
and then attach it to the base fabric at the
appliqué position sewn in step
adhesive to the back of the appliqué piece,
and then attach it to the base fabric at the
appliqué position sewn in step
e
.
g
After the appliqué piece is attached, press the
“Start/Stop” button to sew the appliqué.
“Start/Stop” button to sew the appliqué.
→ The appliqué is then completed.
h
Change the upper thread, and then finish
embroidering the remainder of the pattern.
embroidering the remainder of the pattern.
If the Bobbin Runs Out of Thread
If the bobbin begins to run out of thread during
embroidering, the machine stops and the following
message appears. Replace the bobbin thread according
to the following procedure. If very little sewing remains,
embroidering, the machine stops and the following
message appears. Replace the bobbin thread according
to the following procedure. If very little sewing remains,
press
to sew 10 stitches without rethreading the
machine.
The machine stops after sewing the 10 stitches.
The machine stops after sewing the 10 stitches.
a
Press .
b
Press the “Thread Cutter” button to trim the
threads.
threads.
c
Press the “Presser Foot Lifter” button to raise
the presser foot.
the presser foot.
d
Raise the frame-securing lever, and then
remove the embroidery frame.
remove the embroidery frame.
e
Replace the bobbin with a full one, and then
reattach the embroidery frame.
reattach the embroidery frame.
Note
If the appliqué fabric is a lightweight fabric, you may
want to use a fusible web to stabilize the fabric and to
attach it to the base fabric. Do not remove the base
fabric from the embroidery frame when ironing on the
appliqué piece.
want to use a fusible web to stabilize the fabric and to
attach it to the base fabric. Do not remove the base
fabric from the embroidery frame when ironing on the
appliqué piece.
Memo
Depending on the pattern that is selected, “Appliqué”
may not appear, but instead will appear as a color. If
“Appliqué” appears as a color, embroider using thread
of that color.
may not appear, but instead will appear as a color. If
“Appliqué” appears as a color, embroider using thread
of that color.
Note
• If glue is attached to the presser foot, needle or
needle plate, finish embroidering the appliqué
pattern, and then clean off the glue.
pattern, and then clean off the glue.
• For best results, trim all excess threads between
pattern parts.
Note
• Be careful not to apply a strong force to the hooped
fabric.
• When removing and reattaching the embroidery
frame, do not allow the frame to hit the carriage or
the presser foot, otherwise the pattern may become
misaligned.
the presser foot, otherwise the pattern may become
misaligned.