Инструкции Пользователя для Brother 3034D
SEWING
Se
wing Ba
sics
39
2
h
To stop sewing, press the “Start/Stop” button
again.
again.
i
Press the “Thread Cutter” button to trim the
threads.
threads.
→ The needle automatically stops in the raised
position.
j
When the needle has stopped moving, raise
the presser foot and remove the fabric.
the presser foot and remove the fabric.
■ Using the Foot Controller
You can also use the foot controller to start and stop
sewing.
sewing.
a
Insert the foot controller plug into its jack on
the machine.
the machine.
a Foot controller
b Foot controller jack
b Foot controller jack
b
Slowly press the foot controller to start
sewing.
sewing.
c
Release the foot controller to stop the
machine.
machine.
CAUTION
• Do not press the “Thread Cutter” button after the
threads have been cut. Doing so could tangle the
thread or break the needle and damage the machine.
thread or break the needle and damage the machine.
• Do not press the “Thread Cutter” button when there
is no fabric set in the machine or during machine
operation. The thread may tangle, possibly resulting
in damage.
operation. The thread may tangle, possibly resulting
in damage.
Note
When cutting thread thicker than #30, nylon thread or
other decorative threads, use the thread cutter on the
side of the machine.
other decorative threads, use the thread cutter on the
side of the machine.
Note
This machine is equipped with a bobbin thread sensor
that warns you when the bobbin thread is almost
empty. When the bobbin thread is nearly empty, the
machine stops automatically and a message appears
in the screen. When this message appears, change
the bobbin with one full of thread. However, if the
“Start/Stop” button is pressed, a few stitches can be
sewn.
that warns you when the bobbin thread is almost
empty. When the bobbin thread is nearly empty, the
machine stops automatically and a message appears
in the screen. When this message appears, change
the bobbin with one full of thread. However, if the
“Start/Stop” button is pressed, a few stitches can be
sewn.
CAUTION
• Do not allow fabric pieces and dust to collect in the
foot controller. Doing so could cause a fire or an
electric shock.
electric shock.
Memo
• When the foot controller is being used, the “Start/
Stop” button has no effect on sewing.
• The foot controller cannot be used when
embroidering.
Memo
The speed set using the sewing speed controller is the
foot controller’s maximum sewing speed.
foot controller’s maximum sewing speed.
Memo
(For U.S.A. only)
Foot controller: Model T
This foot controller can be used with model NV1500D/
NV1500.
NV1500.
b
a