Справочник Пользователя для Brother DSMOBILE 600
9
INSTALLING HARDWARE
Do not connect the scanner to your computer until instructed to do so by the driver
installation software. When instructed to do so, connect the scanner cable as shown below
and follow the instructions.
After you have installed the software (Steps 1-4, p. 2-4), Step 5 will instruct you to install
your scanner. You may also follow the steps below if the software has already been
installed. Otherwise, proceed to Calibration.
installation software. When instructed to do so, connect the scanner cable as shown below
and follow the instructions.
After you have installed the software (Steps 1-4, p. 2-4), Step 5 will instruct you to install
your scanner. You may also follow the steps below if the software has already been
installed. Otherwise, proceed to Calibration.
1.
Connect the USB cable to the scanner and to a USB port on your computer as
shown below (either to a desktop or laptop computer). If necessary, please
check your computer’s user guide to identify the USB ports available and their
locations.
shown below (either to a desktop or laptop computer). If necessary, please
check your computer’s user guide to identify the USB ports available and their
locations.
2.
The computer will automatically detect a new hardware device and MAY, during
the initial installation, advise you to follow the Hardware Wizard installation (see
below). If the Hardware Installation Wizard screen is not displayed, go to Step
4.
the initial installation, advise you to follow the Hardware Wizard installation (see
below). If the Hardware Installation Wizard screen is not displayed, go to Step
4.