Инструкции Пользователя для Brother UM BC 1000

• When lowering the presser foot, do not push

in the front of the presser foot, otherwise the
buttonhole will not be sewn with the correct
size.

a Do not reduce the gap.

Pull down the buttonhole lever as far as
possible.

a Buttonhole lever

The buttonhole lever is positioned behind the
bracket on the buttonhole foot.

a Buttonhole lever
b Bracket

Gently hold the end of the upper thread in
your left hand, and then start sewing.

Once sewing is completed, the
machine automatically sews
reinforcement stitches, then stops.

Raise the presser foot lever, remove the
fabric, and cut the thread.

Raise the buttonhole lever to its original
position.

Insert a pin at the end of the buttonhole
stitching to prevent the stitching from being
cut, and then use a seam ripper to cut towards
the pin and open the buttonhole.

a Seam ripper
b Pin

For keyhole buttonholes, use a commercial
eyelet punch to make a hole in the rounded
end of the buttonhole, and then use the seam
ripper to cut open the buttonhole.

a Eyelet punch

• When using the eyelet punch, place thick

paper or some other protective sheet under
the fabric before punching the hole in the
fabric.

Memo

● Before sewing buttonholes, check the stitch

length and width by sewing a trial
buttonhole on a scrap piece of fabric.

● When opening the buttonhole with the seam

ripper, do not place your hands in the cutting
direction, otherwise injuries may result if the
seam ripper slips.

CAUTION