Справочник Пользователя для Infiniti PS-10

5

PS-10/PS-12

S

YSTEM

C

ONNECTIONS

If your receiver/processor does
not contain a Dolby Digital or 
DTS processor but has 
subwoofer outputs:

Set line-level/LFE switch to
“Normal.”

NOTE: If your receiver/processor
has only one sub out, you may use
either the L or R input.

If you have a Dolby* Digital or
DTS

®

receiver/processor with a

low-frequency-effects (LFE) or
subwoofer output:

For LFE use L or R

Green: On

Red: Stand-By

For LFE use L or R

Green: On

Red: Stand-By

For LFE use L or R

Green: On

Red: Stand-By

Set LFE/Normal switch to “LFE.”

LOOSEN TERMINALS

INSERT BARE END; 
TIGHTEN TERMINALS

BLACK =  

–

NO STRIPE =  

–

STRIPE =  

+

RED =  

+

This figure shows how to connect bare wires to the terminals.

If your receiver/processor does not have
subwoofer outputs for the left and right
channels or an LFE output, connect
speaker wire from your receiver/amplifier
to your speakers and subwoofer using
two sets of speaker wire: