Справочник Пользователя для Brother PE-DESIGN V7

Tutorial

Click

under

Programmable fill.

→ The Browse dialog box appears, allowing

you to preview and browse through the
existing programmable fill stitch patterns.

Select pat07, and then click OK.

→ The dialog box closes and a preview of the

selected stitch appears at the bottom of
the Sewing Attribute Setting dialog box.

To change the size, move the slider to the right
until it is set to 10.0

× 10.0 mm (0.39 × 0.39 inch).

→ The Sewing Attribute Setting dialog box

appears as shown below.

To change the direction of the fill stitching,
click Constant, move the pointer over the red
arrow inside of the circle, and then drag the
red arrow until 340 degrees is selected.

Memo:

• The preview of the stitch pattern at the

bottom of the dialog box changes each time
a setting is changed. This allows you to see
how each setting affects the pattern.

• The width and height of the pattern can be

changed separately. (For more details, refer
to “Programmable fill stitch” on page 157.)