Инструкции Пользователя для Brother NC21SE

3

a Carriage

The carriage moves the embroidery frame automatically when 
embroidering.

b Release button (located under the embroidery unit)

Press the release button to remove the embroidery unit.

c Feed dog position switch

Use the feed dog position switch to raise and lower the feed 
dogs while the embroidery unit is attached.

d Embroidery unit connection

Insert the embroidery unit connection into the connection port 
when attaching the embroidery unit.

e Embroidery frame holder

Insert the embroidery frame into the embroidery frame holder to 
hold the frame in place.

f Frame-securing lever

Press the frame-securing lever down to secure the embroidery 
frame.

a “Start/Stop” button

Press this button and the machine will sew a few stitches at a 
slow speed and then begin sewing at the speed set by the 
sewing speed controller. Press the button again to stop the 
machine. Hold the button in to sew at the machine’s slowest 
speed. The button changes color according to the machine’s 
operation mode.

b “Reverse/Reinforcement Stitch” button

Use this button to sew reinforcement stitches at the beginning 
and end of sewing. Press this button, and the machine sews 3 
stitches in the same spot and stops automatically. For straight 
and zigzag stitch patterns that take reverse stitches, the 
machine will sew reverse stitches at low speed only while 
holding down the “Reverse/Reinforcement Stitch” button (the 
stitches are sewn in the opposite direction).

c “Needle Position” button

Use this button when changing sewing direction or for detailed 
sewing in small areas. Press this button to raise or lower the 
needle position. Press the button twice to sew a single stitch.

d “Thread Cutter” button

Press this button after sewing to automatically trim the excess 
thread.

e “Presser Foot Lifter” button

Press this button to lower the presser foot and apply pressure to 
the fabric. Press this button again to raise the presser foot.

f Sewing Speed controller

Use this controller to adjust the sewing speed. Move the slide to 
the left to sew at slower speeds. Move the slide to the right to 
sew at higher speeds. Beginners should sew at a slow speed.

g “Automatic Threading” button

Use this button to automatically thread the needle.

• Be sure that the feed dog position switch on 

the embroidery unit is located at right when 
embroidering.

• You can also sew utility/decorative stitches 

with the embroidery unit attached. Set the 
feed dog position switch on the embroidery 
unit to the appropriate setting.

e

f

d

a

c

b

Green:

the machine is ready to sew or is sewing.

Red:

the machine cannot sew.