Справочник Пользователя для Brother LK3-B448E

9

LK3-B448E MARK

II

/BA-16

1. Remove the 12 screws 

q

, and then open the covers (panel mounting assembly 

w

 and main P.C. board mounting

plate 

e

).

When opening the cover, hold it securely so that it does not fall down.

2. Install the control box with the four accessory bolts 

r

, cushions 

t

, cushion collars 

y

, rubber collars 

u

, flat

washers 

i

 and nuts 

o

 as shown in the illustration above. At this time, leave a gap of approximately 3 mm between

the work table and the top of the box.

* Use two nuts 

o 

at each installation location, and make sure that both nuts are tightened.

3. Close the covers (panel mounting assembly 

w

 and main P.C. board mounting plate 

e

), and tighten them with the

screws 

q

.

* The main P.C. board mounting plate 

e

 will be opened again during “3-13. Connecting the cords”, so provisionally

tighten it with the screw 

q

.

4. Install the power switch 

!0

 with the two screws 

!1

.

5. Secure the power switch cord with the three staples 

!2

.

6. Pass the motor cord through the cord hole 

!3

.

Cushions
Cushion collars

Rubber collars

Flat washers

Nuts

3 mm

Table