Справочник Пользователя для Brother KE-430FX

10. TABLE OF ERROR CODES 

 

 

72

KE-430FX/KE-430FS, BE-438FX

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet 

before opening the face plate of the control box. Touching areas where high voltages are present can result in 

severe injury.

 

If a malfunction should occur with the sewing machine, a buzzer will sound and an error code will appear in the display 

window. Follow the remedy procedure to eliminate the cause of the problem. 

 

Code 

Cause and remedy

The sewing machine started when the work clamp/button clamp was not lowered.   

First lower the work clamp/button clamp. 

The needle bar is not in the needle up stop position. 

Turn the pulley until this error display disappears. 

 
Switch-related errors 

Code 

Cause and remedy

The STOP switch was pressed.   

Press the RESET key to clear the error. 

The STOP switch was pressed.     

Press the RESET key to clear the error.     

You can press the    key to move the work clamp so that you can continue sewing. 

The STOP switch was pressed.   

Press the RESET key to clear the error, and then depress the foot switch to the 2nd step to carry out home 

position detection. 

The STOP switch was still being pressed when the power was turned on, or there is a problem with the STOP 

switch connection.   

Turn off the power, and then check that connector P9 on the main P.C. board is properly connected. 

Problem with the STOP switch connection when the power was turned on. 

Turn off the power, and then check that connector P9 on the main P.C. board is properly connected. 

The foot switch was depressed to the 2nd step when the power was turned on. 

(Start switch for a two-pedal foot switch). 

Turn off the power and check the foot switch. 

The foot switch was depressed to the 1st step when the power was turned on. 

(Work clamp switch for a two-pedal foot switch). 

Turn off the power and check the foot switch. 

Machine head tilting was detected after the power was turned on.

Turn off the power, and then return the machine head to its original position. 

Check that connector P14 on the main P.C. board is properly connected. 

Machine head tilting was detected while the sewing machine was operating.

Turn off the power, and then check that connector P14 on the main P.C. board is properly connected. 

Machine head tilting was detected when the power was turned on.

Turn off the power, and then return the machine head to its original position. 

Check that connector P14 on the main P.C. board is properly connected. 

An operation panel key was still being pressed when the power was turned on, or key is faulty. 

Turn off the power and check the operation panel.