Справочник Пользователя для Brother DH4-B980

3.INSTALLATION

RH-9800

5

Raising the machine head

1. While holding the handles of the machine head (1) with both hands, gently raise the machine head.

Note:  Be sure to turn the power supply off before raising the machine head.

2. If you wish to keep the machine head in the raised position, insert the head support lever (2) securely into the hinge

lever support shaft (3).
Note: Always check that the head support lever (2) and the hinge lever support shaft (3) are meshed.

Lowering the machine head

Pull the machine head down toward you gently, remove the head support lever (2) from the hinge lever support shaft
(3), and then gently lower the machine head.
Note: Do not hold the machine head by the feed bracket (4) or X feed shaft A (5) when it is being raised and

lowered.

3-4. Installing the oil container

1. Install the oil draining cap support (2) to the base of

the bed stand (1) with the two screws (3).

2. Screw the oil container (4) into the oil draining cap

support (2).

3. Push the oil draining spring pin (5) into the bed stand

(1) until the pin is flush with the surface of the stand.

4. Lower the machine head. (Refer to "Lowering the

machine head" above.)

When machine head is raised

0810Q

0809Q

When machine
head is lowered

(2)

(3)

(1)

(5)

0811Q

0812Q

(5)

(1)

(5)

(1)

(2)
(3)

(3)

(4)

(4)

(1)

(2)

(3)