Справочник Пользователя для Brother DH4-B980
5. CORRECT USE
RH-9800
18
5-7. Threading the gimp
Remove the cloth presser plates (refer to page 13), and then thread the gimp as shown in the illustration below.
Once threading is complete, replace the cloth presser plates.
Once threading is complete, replace the cloth presser plates.
5-8. Setting the material
1. Insert the material so that it touches the right and left cloth guides (1).
2. The sewing margin can be adjusted to within 10 - 30 mm.
3. Loosen the screws (2) at left and right and move the cloth guides (1) back and forth to adjust the sewing margin.
2. The sewing margin can be adjusted to within 10 - 30 mm.
3. Loosen the screws (2) at left and right and move the cloth guides (1) back and forth to adjust the sewing margin.
<-00, -01>
<-02>
0884Q
0885Q
0886Q
Pass the gimp through the hole of
the thread tension stud (1).
the thread tension stud (1).
Refer to “9-17. Adjusting the gimp length after trimming (-02)” (Page 54).
10 - 30 mm
(1)
(2)
(2)
(1)
(2)
(1)
(2)
0889Q
0890Q
(1)