Справочник Пользователя для Brother 885-V12/V13
GETTING READY ———————————————————————————————————————————————————————————————————————————————————————————————————————
24
b
Cut the thread with the thread cutter on the
left side of the machine.
left side of the machine.
a Thread cutter
Note
● When using thread that quickly winds off
the spool, such as metallic thread, it may be
difficult to thread the needle if the thread is
cut.
Therefore, instead of using the thread cutter,
pull out about 80 mm (approx. 3 inches) of
thread after passing it through the thread
guide disks (marked “7”).
difficult to thread the needle if the thread is
cut.
Therefore, instead of using the thread cutter,
pull out about 80 mm (approx. 3 inches) of
thread after passing it through the thread
guide disks (marked “7”).
a 80 mm (3 inches) or more
c
Lower the needle threader lever on the left
side of the machine, and then slowly return
the lever to its original position.
side of the machine, and then slowly return
the lever to its original position.
a Needle threader lever
X
The thread is passed through the eye of
the needle.
the needle.
Note
● If the needle was not completely threaded,
but a loop in the thread was formed in the
eye of the needle, carefully pull the loop
through the eye of the needle to pull out the
end of the thread.
eye of the needle, carefully pull the loop
through the eye of the needle to pull out the
end of the thread.
a
1
● When pulling out the thread, do not pull it
with extreme force, otherwise the needle may
break or bend.
break or bend.
a
CAUTION