Справочник Пользователя для Brother 882-W07
SEWING THE STITCHES
U
tili
ty
ty
S
tit
ch
es
139
3
c
Check that the needle drops at the desired
position and lower the presser foot, making
sure the upper thread passes underneath
the buttonhole foot.
position and lower the presser foot, making
sure the upper thread passes underneath
the buttonhole foot.
d
Lower the buttonhole lever so that it is
positioned behind the metal bracket on the
buttonhole foot.
positioned behind the metal bracket on the
buttonhole foot.
a Buttonhole lever
a Metal bracket
e
Gently hold the end of the upper thread,
and then press the “Start/Stop” button to
start the machine.
and then press the “Start/Stop” button to
start the machine.
→ Once sewing is completed, the machine
automatically sews reinforcement stitches, and then
stops.
stops.
Note
• Pass the thread underneath the presser
foot.
• Set the presser foot so that there is no gap
behind the section marked with an “A” (the
shaded area in the illustration below). If
there is a gap, the size of the darning will not
be correct.
shaded area in the illustration below). If
there is a gap, the size of the darning will not
be correct.
Memo
• If automatic thread cutting is turned on
before you start sewing, both threads are
automatically cut after the reinforcement
stitches are sewn. If the fabric does not feed
(for example, because it is too thick),
increase the stitch length setting.
automatically cut after the reinforcement
stitches are sewn. If the fabric does not feed
(for example, because it is too thick),
increase the stitch length setting.