Справочник Пользователя для Brother 882-S90/S91
SEWING THE STITCHES
88
Bar Tacks
Use bar tacks to reinforce areas that will be subject to strain, such as pocket corners.
a
Select .
b
Attach buttonhole foot “A” and set the
scale to the length of the bar tack you wish
to sew.
scale to the length of the bar tack you wish
to sew.
a Presser foot scale
b Completed length measurement
b Completed length measurement
c 5 mm (approx. 3/16 inch)
c
Set the fabric so that the pocket moves
towards you during sewing.
towards you during sewing.
d
Check the first needle drop point and lower
the presser foot.
the presser foot.
a 2 mm (approx. 1/16 inch)
Stitch
Stitch name
Presser
foot
Applications
Stitch width
[mm (inch.)]
[mm (inch.)]
Stitch length
[mm (inch.)]
Twin
needle
Auto.
Manual
Auto.
Manual
Bar tack
Reinforcement at opening of
pocket, etc.
pocket, etc.
2.0
(1/16)
1.0 - 3.0
(1/16 - 1/8)
0.4
(1/64)
0.3 - 1.0
(1/64 - 1/16)
NO
Memo
Bar tacks can be between 5 mm (approx.
3/16 inch) and 28 mm (approx. 1-1/16 inches).
Bar tacks are usually between 5 mm (approx.
3/16 inch) and 10 mm (approx. 3/8 inch).
3/16 inch) and 28 mm (approx. 1-1/16 inches).
Bar tacks are usually between 5 mm (approx.
3/16 inch) and 10 mm (approx. 3/8 inch).
a
c
b
Note
• Pass the thread underneath the presser
foot.
• Slide the outside frame of the buttonhole
foot backward as far as possible as shown in
the illustration, making sure that there is no
gap behind the part of the foot marked “A”. If
the buttonhole foot is not slid back as far as
possible, the bar tack will not be sewn to the
correct size.
the illustration, making sure that there is no
gap behind the part of the foot marked “A”. If
the buttonhole foot is not slid back as far as
possible, the bar tack will not be sewn to the
correct size.
a