Справочник Пользователя для Behringer Super Octaver SO400

Ultimate Octaver Effects Pedal

Thank you for showing your confidence in us by purchasing the BEHRINGER SUPER OCTAVER SO400. This is 

the ultimate octaver with polyphonic input and the capability of creating octaves 1 and 2 octaves below the 

original tone. Take off with ultra-stable octaver sounds plus an aggressive Drive mode for fat overdrive sounds.

(1) 

The MODE switch selects one of the 

following operation modes:
POLY:  Single octave sound 

which allows to play treble tones 

without effect over bass tones with 

octave effect.
OCT 2:  Heavy octave sound, adds a 

second octave to the first one.
DRIVE: Adds an overdrive effect to 

the original and the octaved signal.

(2) 

The DIRECT control adjusts the 

level of the original input signal 

(and the DIR OUT connector). 

In DRIVE mode it adjusts total volume. 

(3) 

The OCT 1 control adjusts the level 

of the generated signal one octave 

below the original signal.

(4) 

The function of this knob depends on 

the position of the MODE switch  (1):
POLY>RANGE: Defines the frequency range in which the input signal triggers the octave effect.
OCT 2>OCT 2:  Controls the volume of the second octave.
DRIVE>DRIVE: Controls the depth of the overdrive effect. 

(5) 

The blue ON/BATT LED illuminates when the effect is activated. It also serves as a battery level indicator.

(6) 

Use the footswitch to activate/deactivate the effect.

(7) 

The ¼" TS connector (GTR IN) is optimized for guitars. Use connector BASS IN  (9)  for optimized 

bass guitar performance.

(8) 

The ¼" TS connector (OUT A) connects to your amp.

(9) 

The ¼" TS connector (BASS IN) is optimized for bass guitars. Use connector GTR IN  (7)  for 

optimized guitar performance.

(10) 

The ¼" TS connector (DIR OUT) passes the unaffected input signal through, as long as the effect 

is inactive. Thus OUT A is muted. When the effect is active, the effects signal is sent through OUT A 

while the DIR OUT carries the input signal. The volume of the DIR OUT signal is depending on the 

DIRECT control’s setting. This output configuration is useful when different effects should be added 

to the input signal and the effect signal, after the octave pedal’s output.  

Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included). 
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery 

(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to scratch the unit.

(2)

(10)

(8)

(5)

(6)

(7)

(9)

(4)

(3)

(1)