Справочник Пользователя для Barco Nio Fusion 4MP

Graphic board control panel

9

• Clone

The primary display is cloned to the secondary display.

• 24-Bit TrueColor Mode
• 30-Bit TrueColor Mode (HDR)

• Sets display resolution for 1 or 2 displays.

Note: To switch out of SingleView or Clone mode, the 
buttons in this Control Panel page must be used. The main 
Windows Control Panel cannot be used. Depending on your 
system, certain configurations can be disabled.

Note: Clone Mode is supported for two color displays or 
projectors in 32bpp. Clone mode is not supported on grayscale 
displays. Also, HDR is not supported while in Clone Mode. 

When choosing Clone Mode under the Barco Adapter 
Configuration page, if two displays are enabled, then the larger 
of the two current resolutions will be used. If only one of the 
two displays is enabled, the enabled displayís current resolution 
will be used. 

When the resolution set for clone mode is larger then the 
maximum supported on a display, the resolution set on the 
Master will automatically be scaled to maximum resolution of 
the Cloned display. If the Scale to Display Preferred Mode is 
checked, the maximum resolution will be the EDID preferred 
mode. If it is unchecked, then it will be the largest mode in the 
Cloned displays mode list. Clone mode can only be exited 
through the Barco Adapter Configuration page in the Barco 
Advanced Control Panel.

Note: Not all options are available at all times. Please select 
the help tips in the driver software for more information.