Справочник Пользователя для Brother TD-2020
Chapter 2
18
Figure 1
2
NOTE
The sensor is at this position immediately
after the printer is purchased.
after the printer is purchased.
Figure 2
2
Figure 3
2
1 Back of media
2 Black mark
3 0.16" (4 mm) or more
4 Centerline
5 Reflective/black mark sensor
NOTE
When using receipt paper with the
maximum width of 2.4" (63 mm), make a
black mark at least 0.35" (9 mm) long in
from either the left or right edge of the
paper so that the reflective/black mark
sensor can detect the black mark. If the
black mark is too short, it cannot be
detected by the reflective/black mark
sensor.
maximum width of 2.4" (63 mm), make a
black mark at least 0.35" (9 mm) long in
from either the left or right edge of the
paper so that the reflective/black mark
sensor can detect the black mark. If the
black mark is too short, it cannot be
detected by the reflective/black mark
sensor.
Cutting Roll Paper
2
Roll paper can be cut using the printer’s tear
bar. Pull one edge of the ejected paper up
and diagonally toward the other edge.
bar. Pull one edge of the ejected paper up
and diagonally toward the other edge.
CAUTION
The tear bar is sharp. To avoid injury, do not
touch the tear bar.
touch the tear bar.
1
2
3
4
5