Инструкции Пользователя для Brother FAX 2750

S E T U P S E N D

If you’re sending a fax manually and the line is busy, after you disconnect
the call press 

Redial/Pause

 to retry the number.

If you’re sending a fax automatically and the line is busy, the fax machine
will automatically redial up to three times at 5 minute intervals.

You can scan up to 50 documents into the fax memory, even while the fax
machine is receiving or sending another fax (from memory). You can set
temporary settings for each fax you’re scanning, except Timer and Polling.

If you try to scan in and store a 51st fax, the fax machine will send it
immediately, without storing it in memory.

If you get a MEMORY FULL message while scanning the first page of a
fax, press 

Stop

 to cancel scanning.  If you get a MEMORY FULL message

while scanning in a subsequent page, you'll have the option to press 

Start

 to

transmit the pages scanned so far, or to press 

Stop

 to cancel the operation.

Make sure the document feeder is empty.

Place the document in the feeder.

Enter the fax number.

Press 

Start

.  The fax machine starts scanning the document and the

screen displays the job number (#XX) of the fax, and how much
memory is available. Then the fax machine starts dialing. You can
immediately repeat Steps 1 through 4 for the next fax.

Your fax machine normally operates in Dual Access mode. However, you
can override Dual Access by using Real Time Transmission.

When memory is full, the fax machine cannot continue to scan documents
into memory before sending.  However, you can turn on REAL TIME TX.
Then place the documents in the feeder and enter the fax number.  As soon
as the phone line is free, the fax machine starts dialing and sending the fax.

Place the document in the feeder.

Press 

Function

, 

3

, 

9

.

The screen displays

   

9.REALTIME TX:OFF?