Инструкции Пользователя для Brother SU-877A
50
Programmer
Chapter 2 Programming with Help Function
2.
Select
with
and press
.
3.
Move the work clamp with
. Press
when the needle point is at point 1 of the
pattern.
The first stitch (point 1) is programmed.
4.
Select
with
and press
.
5.
Input the stitch length and the number of lines
for a multiple stitch. Press
for a multiple stitch. Press
.
"2.0 mm" is input for a stitch length in the
example.
Input "030" to make the stitch length to 3.0 mm.
To switch input between the stitch length and the
number of lines, use
Input "030" to make the stitch length to 3.0 mm.
To switch input between the stitch length and the
number of lines, use
.
6.
Move the work clamp with
. Press
when the needle point is at point 2 of the
pattern.
7.
Move the work clamp with
. Press
when the needle point is at point 3 of the
pattern.
Be sure to press
twice for a split at a corner
like point 3. If a split is not made, the corner will
be round.
be round.
8.
Program the following points up to point 17 with
the curve programming steps.
the curve programming steps.
When there is a liner section, move the needle
point from the split to the next split, and press
twice.
In the example, a linear line is programmed
point from the split to the next split, and press
twice.
In the example, a linear line is programmed
between points 7 and 9. Be sure to program a
linear line also for the matched section between
points 24 and 26.
By pressing
By pressing
, the needle point is returned to
the previous point. It cannot be returned beyond
the previous split.
By pressing
By pressing
, the needle point is returned to
the previous split. However, when the needle
point is at a split, it cannot be moved.
By pressing
By pressing
, the needle point is returned to
the split before the previous split.
9.
Press
. Move the work clamp with
. Press
when the needle point is
at point 18 of the pattern.