Справочник Пользователя для Brother PE-600II
Resume Embroidering After Turning OFF the Machine 83
3
Resume Embroidering After Turning OFF the Machine
In either of the following cases, the remaining stitches of the embroidery are stored in the machine’s memory.
• If the machine's power switch is pressed to turn off after stopping embroidering.
• If the machine's power switch is pressed to turn off after stopping embroidering.
Cut the thread before the machine's main power switch is turned off, otherwise the thread may be pulled or
may catch when the carriage returns to its initial position after the machine is turned on again.
may catch when the carriage returns to its initial position after the machine is turned on again.
• If the machine was accidentally turned off, for example, due to a power outage, while it was embroidering.
The remainder of the embroidery can be sewn when the machine is turned on again; however, some of the
stitches that were already sewn may be sewn again.
stitches that were already sewn may be sewn again.
Note
● Be careful when going back or forward
through the stitching since the embroidery
frame moves at the same time.
frame moves at the same time.
1
Set the main power switch to “I” to turn on
the machine.
the machine.
2
When the screen shown below appears after
the initial screen, touch
.
X
A message appears, asking if you wish to
continue embroidering or start a new
operation.
continue embroidering or start a new
operation.
Sapphire_brother.book Page 83 Thursday, November 17, 2005 2:48 PM