Справочник Пользователя для Brother PE-600II

Starting/Ending Position Settings     89

The machine can set the start point and the ending point separately from the 9 points of the pattern. Those are 
upper-left corner, upper-center, upper-right corner, center-left, center-center, center-right, lower-left corner, 
lower-center and lower-right corner.
These settings can be used to repeatedly sew a pattern along a diagonal.

The starting/ending position settings are specified 
from the embroidering settings screen.
When the embroidery machine is purchased, both 
the starting position and the ending positions are set 
to the center of the pattern.

1

X

The starting/ending position settings screen 
appears.

1 Specifies the starting position
2 Specifies the ending position

Touch a key to select the setting.
The highlighted key shows the currently selected 
setting.

Example

3 Touch this key to close this screen.

■ Specifying the starting position

2

X

When a starting position is selected, the 
ending position is automatically set to the 
same position.

X

The embroidery frame moves to the starting 
position.

■ Specifying the ending position

3

4

X

The embroidering settings screen appears 
again.

● The starting/ending position settings do not 

change until the key for a new setting is 
touched. The settings specified before the 
machine is turned off remain selected the 
next time that the machine is turned on.

This key is selected.

Sapphire_brother.book  Page 89  Thursday, November 17, 2005  3:00 PM