Справочник Пользователя для Brother PE-600II
Using the Optional Cap Frame 173
7
■ Adjusting the cap frame driver
1 L-shaped bracket
2 Ring
2 Ring
Memo
● If the same machine is being used, the
adjustment to the cap frame driver is only
required the first time that the machine is
used.
required the first time that the machine is
used.
1
Turn on the machine. After the carriage
moves to its initial position, turn off the
machine.
moves to its initial position, turn off the
machine.
Note
● Be sure to adjust the cap frame driver with
the carriage at its initial position.
2
Using the Allen screwdriver (medium), loosen
the two hexagonal screws. Loosen the screws
only by about one turn.
the two hexagonal screws. Loosen the screws
only by about one turn.
1 Hexagonal screws
2 Allen screwdriver (medium)
2 Allen screwdriver (medium)
Note
● Do not loosen them too far.
3
Lower the L-shaped bracket to make it touch
the machine bed and then tighten the two
hexagonal screws using the Allen screwdriver
(medium). Firmly tighten the screws.
the machine bed and then tighten the two
hexagonal screws using the Allen screwdriver
(medium). Firmly tighten the screws.
1 L-shaped bracket
4
Using the Allen screwdriver (large), loosen the
four hexagonal screws on the inside of the
ring. Loosen the screws only by about one
turn.
four hexagonal screws on the inside of the
ring. Loosen the screws only by about one
turn.
1 Hexagonal screws
2 Allen screwdriver (large)
2 Allen screwdriver (large)
X
When the screws are loosened, the ring can
be lowered.
be lowered.
Note
● Do not loosen them too far.
Sapphire_chapt7.fm Page 173 Friday, November 18, 2005 12:10 PM