Справочник Пользователя для Brother PE-600II
APPENDIX ——————————————————————————————————————————————————————————
178
6
Close the clamping frame, and then hook the
catch of the snap lock to temporarily secure
it.
catch of the snap lock to temporarily secure
it.
1 Catch of the snap lock
2 Clamping frame
2 Clamping frame
Check for the following conditions.
1 The centerline of the cap is parallel with
1 The centerline of the cap is parallel with
the short side of the clamping frame.
2 The line on the left side of the cap cannot
be seen within the clamping frame.
3 The teeth on the inside of the clamping
frame cleanly grab the base of the brim.
4 The centerline of the brim holder and the
center line of the cap must make a single
straight line.
straight line.
1 Teeth on the inside of the clamping frame
2 Centerline of brim holder
2 Centerline of brim holder
Memo
● According to the shape of the cap, loosen
the screw 4 and adjust the position of the
clamping frame 3 so that the teeth on the
inside of the clamping frame 1 align with
the base of cap brim 2.
clamping frame 3 so that the teeth on the
inside of the clamping frame 1 align with
the base of cap brim 2.
Memo
● If the cap fabric is thick and the clamping
frame cannot be closed, or if the fabric is
thin and the cap is too loose within the
frame, adjust the clamping frame.
thin and the cap is too loose within the
frame, adjust the clamping frame.
1
2
3
4
Sapphire_chapt7.fm Page 178 Friday, November 18, 2005 12:10 PM