Справочник Пользователя для Brother PE-600II
Upper Threading 41
2
Note
● If the thread is not taut, it may come out of
the thread tension disc. After upper
threading is finished, check again to make
sure that the thread is correctly passed into
the thread tension disc. (Refer to step
threading is finished, check again to make
sure that the thread is correctly passed into
the thread tension disc. (Refer to step
5
on
page 37.)
Memo
● When changing one of the upper thread
colors, it is easy to re-thread by cutting the
thread currently being used between the
spool and the thread guide above the spool.
Place the new spool on the spool pin and
tie the end of the new thread to the end of
the previous thread. Then pull the thread
through to the needle. (Refer to page 78.)
thread currently being used between the
spool and the thread guide above the spool.
Place the new spool on the spool pin and
tie the end of the new thread to the end of
the previous thread. Then pull the thread
through to the needle. (Refer to page 78.)
■ Using the spool net
When using metallic thread or any other strong
thread, place the included spool net over the
spool before sewing.
If the spool net is too long, fold it once to match
the size of the spool before placing it over the
spool.
It may be necessary to adjust thread tension when
using the spool net.
thread, place the included spool net over the
spool before sewing.
If the spool net is too long, fold it once to match
the size of the spool before placing it over the
spool.
It may be necessary to adjust thread tension when
using the spool net.
1 Spool net
2 Thread
2 Thread
1
2
3
4
5
6
7
8
9
10
11
12
13
14
2
1
Sapphire_brother.book Page 41 Thursday, November 17, 2005 2:48 PM