Справочник Пользователя для Brother PE-600II

Changing the Needle     63

If the needle is bent or the tip of the needle is broken, replace the needle with a new one. Use the included allen 
screw driver to replace the needle with one that is designed specifically for this machine and that passes the test 
described in “Checking the needle” (on page 15).

1

2

Loosen the needle set screw and remove the 
needle.
Hold the needle with your left hand, and then 
hold the allen screw driver in your right hand 
and turn the needle set screw 
counterclockwise.

● Be sure to use the included allen screw 

driver to replace the needle, otherwise too 
much force may be applied to the needle, 
causing it to break.

• Do not apply extreme force when loosening 

or tightening the needle set screw, otherwise 
the machine may be damaged.

3

With the flat side of the needle toward the 
back of the machine, insert the needle all the 
way up until it touches the needle bar stopper.
Pass the needle through the hole in the presser 
foot, and then use the needle changing tool to 
lift up the needle.

1 Needle bar stopper
2 Needle
3 Flat side of needle
4 Needle changing tool

●

1

2

3

4

Sapphire_brother.book  Page 63  Thursday, November 17, 2005  2:48 PM