Справочник Пользователя для Brother 885-S61

Скачать
Страница из 156
Upper Threading     27
1
Threading the needle
Memo
● The needle threader can be used with 
sewing machine needles 75/11 through 
100/16.
● The needle threader cannot be used with 
the wing needle or the twin needle.
● If the needle threader cannot be used, refer 
to “Threading the needle manually (without 
using the needle threader)” on page 28.
1
Pull the end of the thread, which has been 
passed through the needle bar thread guide, 
to the left, then pass the thread through the 
notch of the thread guide 
1, and then firmly 
pull the thread from the front and insert it into 
the slit of the thread guide disk marked “7” all 
the way 
2.
Make sure that the thread passes the notch of 
the thread guide.
1 Notch of the thread guide
2 Thread guide disk
2
Cut the thread with the cutter on the left side 
of the machine.
1 Thread cutter
3
Lower the presser foot lever.
1 Presser foot lever
X
The presser foot is lowered.
4
Lower the needle threader lever until it clicks.
1 Needle threader lever
X
The thread is passed through the eye of the 
needle.
5
Release the needle threader lever.
6
Carefully pull on the loop of thread passed 
through the eye of the needle to pull out the 
end of the thread.
7
Raise the presser foot lever, pass the thread 
through the presser foot, and then pull out 
about 5 cm (2 inch) of thread toward the rear 
of the machine.
X
The upper threading is finished.
Now that the upper threading and the lower threading 
are finished, you are ready to begin sewing.
1
2
2
1
5
1
1 5 cm (2 inch)
1
1
1