Справочник Пользователя для Brother 885-V31
88
UTILITY STITCHES
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Button sewing
Buttons can be sewn on with the sewing machine.
Buttons with two or with four holes can be attached.
Buttons with two or with four holes can be attached.
a
Measure the distance between the holes in the
button to be attached.
button to be attached.
b
Raise the presser foot lever, and then slide the
drop feed lever, located at the rear of the
machine on the base, to
drop feed lever, located at the rear of the
machine on the base, to
(to the left as seen
from the rear of the machine).
a Drop feed lever (as seen from the rear of the
machine)
X
The feed dogs are lowered.
c
Attach button-fitting foot "M".
• For details on replacing the presser foot, refer
to "Replacing the presser foot" (page 43).
d
Select stitch
61
.
• For details, refer to "Selecting stitching" (page
49).
Note
z Since the end of the thread will be tied off
later, do not set the sewing machine for
programmed-thread cutting.
programmed-thread cutting.
e
Adjust the stitch width so that it is the same as
the distance between the holes in the button.
the distance between the holes in the button.
f
Place the button in the position where it will
be sewn, and lower the presser foot lever.
be sewn, and lower the presser foot lever.
a Button
X
The button is held in place.
Memo
z When attaching four-hole buttons, first sew
the two holes closest to you. Then, slide the
button so that the needle goes into the two
holes toward the rear of the sewing
machine, and then sew them in the same
way.
button so that the needle goes into the two
holes toward the rear of the sewing
machine, and then sew them in the same
way.
g
Turn the handwheel toward you
(counterclockwise) to check that the needle
correctly goes into the two holes of the button.
Adjust the stitch width to the distance between
the button holes.
(counterclockwise) to check that the needle
correctly goes into the two holes of the button.
Adjust the stitch width to the distance between
the button holes.
CAUTION
a
● When sewing, be sure that the needle
does not touch the button, otherwise the
needle may bend or break.
needle may bend or break.
a