Справочник Пользователя для Brother NV1000
Attaching the Embroidery Frame 143
4
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Attaching the Embroidery Frame
This section describes how to attach the embroidery frame.
Attaching the embroidery
frame
frame
a
Wind the embroidery bobbin thread onto the
bobbin and set it into the bobbin case.
bobbin and set it into the bobbin case.
• For details, refer to "Winding/Installing the
Bobbin" (page 23).
b
Raise the presser foot lever.
a Presser foot lever
c
Pass the embroidery frame under the presser
foot while raising the presser foot lever even
further.
foot while raising the presser foot lever even
further.
CAUTION
d
While lightly holding the lever on the frame
holder to the left, align the two pins on the
embroidery frame holder with the mounting
bracket on the frame, and then press the frame
into the embroidery frame holder until a click
is heard.
holder to the left, align the two pins on the
embroidery frame holder with the mounting
bracket on the frame, and then press the frame
into the embroidery frame holder until a click
is heard.
a Lever
b Pins
b Pins
• Be sure to insert both pins. If only the forward
or the back pin is inserted, the pattern may
not turn out correctly.
not turn out correctly.
CAUTION
● Do not hit the needle with your finger or
the embroidery frame. It may cause injury
or needle breakage.
or needle breakage.
a
● Correctly set the embroidery frame into
the embroidery frame holder. Otherwise,
the presser foot may hit the embroidery
frame, resulting in injury.
the presser foot may hit the embroidery
frame, resulting in injury.
2
1