Справочник Пользователя для Brother 885-V12
73
3
d
Hold the quilting foot in place with your right
hand, and then tighten the presser foot holder
screw using the enclosed screwdriver in your
left hand.
hand, and then tighten the presser foot holder
screw using the enclosed screwdriver in your
left hand.
e
Slide the feed dog position switch, located at
the rear of the machine on the base, to the
position shown below to lower the feed dogs.
the rear of the machine on the base, to the
position shown below to lower the feed dogs.
a Feed dog position switch (as seen from the
rear of the machine)
f
Turn on the machine.
g
With the pattern selection dial,
select stitch
or
.
h
Use both hands to stretch the fabric taut, and
then move the fabric to follow the pattern.
Reinforcement stitches are sewn at the
beginning and end of stitching.
then move the fabric to follow the pattern.
Reinforcement stitches are sewn at the
beginning and end of stitching.
a Pattern
• Reverse stitches cannot be sewn when the
• Reverse stitches cannot be sewn when the
feed dogs are lowered.
i
After sewing is finished, slide the feed dog
position switch to its original position to raise
the feed dogs.
position switch to its original position to raise
the feed dogs.
• The feed dogs are normally left raised.
Memo
● Turn the handwheel to raise the feed dogs.
● Be sure to securely tighten the screw with the
enclosed screwdriver, otherwise the needle
may touch the presser foot, causing it to bend
or break.
may touch the presser foot, causing it to bend
or break.
CAUTION
a
a