Справочник Пользователя для Wegener Communications 6420

 

 

iPump 6420 User’s Manual

 

www.wegener.com 

800070-01 Rev B 

Chapter 2, Page 26 

 

Before applying power, make the following connections, as necessary, to your 

iPump 6240

. For 

connector details, refer to Table 2-1Error! Reference source not found..  For help deciding which 
connectors and signals to use, consult Chapter 3. 

1)  Connect the L-band output from your antenna's LNB to your 

iPump 6240

's input RF port, 

, if 

supplied with ASI Input interface, connect a coax cable to your ASI Transport source (such as 
another satellite IRD).Connect your balanced analog audio ports (1, 2, or 3 [Aux]) to your 
analog audio distribution system (DA). 

only) to your digital audio distribution system (DA). 

2)   Connect a CAT5 cable from the 

iPump 6240

's LAN port to the desired LAN segment in order to 

access the 

iPump 6240

's web control screen.  If that LAN segment can reach the internet, then this 

may be the only adaptor needed (see next). 

3)  If you wish to have your iPump 6420 be able to send Return Path over internet to the uplink 

control system, then the LAN segment connected to the LAN port must be allowed to make 
outbound HTTP connections, and you must protect the iPump 6420 from inbound 
connections from the internet.  If so, then you may skip the next step. 

4)  Connect a CAT5 cable from the 

iPump 6240

's WAN port to an external broadband internet 

connection.  Remember, this is used only for connections unprotected by NAT router and/or 
firewall.  

5)  Connect the Modem jack to a local analog phone line, if using Return Path, but where the 

Ethernet adaptors cannot be wired to have access to the internet. 

6)  Connect one of more of your 

iPump 6240

 Cue Relays ports to the local commercial insertion 

equipment (if used). 

7)  Connect one or more of your iPump 6420 RBDS output ports to the radio station exciter’s 

RBDS input, if supporting RBDS distribution in this radio network. 

8)  Connect one or more of your iPump 6420 AM/FM tuner inputs to appropriate radio antenna, 

if supplied and using Off-Air Recording audits.  You must be using Return Path to support 
return transmission of recorded OAR files. 

9)  Connect the local automation systems’s relay closure outputs to the PIO Input connector. 
10) For diagnostics, you may connect a text-based monitor to the Serial M&C port. 
11) Connect the Alarm port to downstream redundancy control or alarm monitoring system. 
12) Connect the supplied ac power cord to the 

iPump 6240

's IEC receptacle and then to a  

100-to-120 VAC or 200-to-240 VAC source. 

supplied, the iPump 6240 

begins the startup process and will require about 2 ½ minutes to 

complete.