Листовка для Wahl EAR-NOSE-BROW

Make sure trimmer unit is turned “OFF”.
1 Turn trimmer head 
counterclockwise 1/4 
turn and lift off.
2 Place trimmer head 
on trimmer and turn 
trimmer head clockwise 
1/4 turn to lock on.

Make sure the nasal passages are clean. Slowly 
move the rotary blade/detailer in and out of each 
nostril, no more than

 1/4-inch deep. 

Make sure the outer areas of the ears do not con-
tain any wax. Hold the ear flat with one hand and 
carefully insert rotary blade/detailer no more than 
1/4-inch into the outer ear. CAUTION: Do not insert 
the rotary blade/detailer or any other foreign object 
into the inner ear. For hair growing on the outside 
of the ear, simply move the rotary blade/detailer 
slowly along the edges of the ear.

Slowly move rotary blade/detailer to neatly trim 
stray hairs. For precise, even trimming, slowly 
move the rotary blade/detailer closer or farther 
away from eyebrows to achieve desired length.

To install eyebrow attachment 
comb, you must use the recipro-
cating head and place eyebrow 
attachment comb over it. The 
attachment comb allows you to 
trim and shape eyebrows. Trim 
by following in the direction of 
hair growth.

For detailing sideburns and 
mustache, use detailing head 
across desired areas. For 
trimming sideburns slowly 
move detailing head across 
desired area.

For hard to reach or tight areas, use the detailer 
head. Slowly move the detailer through area to trim 
until desired look is accomplished.

If your Trimmer does not seem to take a charge, 
check the following before returning it for repair:
1. Check outlet current by plugging in another 
appliance.
2. Make sure the outlet simply is not connected to a 
light switch which turns the power at the outlet off 
when lights are turned off.
3. Be sure the trimmer is properly connected to the 
recharging transformer, all connections are secure 
and the switch on the trimmer is turned “OFF - 0.”
4. If your electricity is connected to a master power 
switch, we suggest the trimmer be disconnected 
from the charger anytime the master switch is off. 
Leaving the unit plugged into a dead outlet or an 
unplugged charger will drain the battery.
5. If trimmer does not run and it is completely 
charged, turn the unit “ON - I” and pinch or push 
the blades manually. (Oil may have dried out 
between the blades, so they may be temporarily 
stuck together.)
For the cleaning and care instructions of your 
trimmer, please download the Care Instructions.

SERVICE AND REPAIR

If you have problems with your WAHL product, send 

it prepaid with a note explaining the problem to:

 Wahl Clipper Corporation

Attn: Repair Department

 3001 Locust Street

 Sterling, IL 61081

 Telephone (815) 625-6525

For products purchased outside the United States, 

contact your distributor.