Справочник Пользователя для Sony Water Dispenser 2

  

 Chapt

er

 16

 

Eng

inee

ring
 S
e

tu

p

202

Setup for the Whole System

Select [Yes].

Depending on the selection in step 

, the following is the result.

• When you selected [Reset], a reset is applied to the device causing it to 

be restarted in the start-up state.

• When you selected [All Clear], all memory in the device is cleared, 

including snapshots, keyframe effects, setup, and so on, and the device 
returns to its factory default settings. However, the Network Config, 
Format, Start Up, and Date/Time settings are not initialized.

To install software or firmware in a device, use the System>Install menu.

In the Engineering Setup menu, select VF1 ‘System’ and HF6 ‘Install.’
The status area shows the version of the software installed in each device.

Use the following procedure.

Insert the memory card holding the software into the memory card slot.

Press the [Install] button.

The System>Install>Install menu appears, showing a list of the software 
contained in the memory card.

Using any of the following methods, select the device.

All: When this is on, all devices are selected for the operation.
Plural: When this is on, you can specify a number of devices to which the 

operation will apply. In this case, in the status area, press the desired 
devices, turning them to reverse video. To cancel a selection, press 
once more to return to normal display.

When both of the above buttons are off: You can specify any device in 

the status area.

To carry out installation, press [Execute].

A confirmation message appears.

Select [Yes].

This installs the software.