Справочник Пользователя для Sony Water Dispenser 2

215

Setup Relating to Operations From the Control Panel

  

Ch
apt

er 16 

E

ngin

eering Se

tup

In the <Sub Table Select> group, select the sub table you want to set.

Using any of the following methods, select the cross-point button for 
which you want to make an assignment.

• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the setting.

• To disable operation of a button number, press [Inhibit].

Turn the knob to select the main cross-point button number to be assigned.

In place of steps 

 and 

 in the above procedure, you can use the following 

procedure for the setting.

Press [Source Select].

The Source Select menu appears.
In the upper part of the status area, the selected Sub and Main button 
numbers and the currently assigned video and key signal names appear. In 
the lower part, a list of the assignable signals appears.

Referring to steps 

 and 

, select the signal to be assigned.

You can set the operation of the rightmost button in each row of cross-point 
buttons excluding the reentry buttons.
In the <Xpt Shift Mode> group of the Panel>Xpt Assign>Multi Xpt Assign 
menu, select one of the following for each cross-point table.
Hold: Acts as a shift button, and the shifted version of the cross-point buttons 

is enabled while the button is held down.

Lock: Acts as a shift button, and pressing the button toggles between the 

shifted version and the unshifted version.

Off: Acts as a cross-point button, in a 16-button system as button number 16, 

in a 24-button system as button number 24, and in a 32-button system as 
button number 32.

1

Sub Button No

Sub cross-point button selection

1 to 128

3

Main Source No

Main cross-point button selection 1 to 128