Справочник Пользователя для Sony Water Dispenser 2
81
Global Effect Operations
Cha
p
te
r 11
DME Op
er
at
ion
s
s
Note
It is not possible to make images intersect. If an image is rotated, the priority is
determined by the position on the z-axis of the center of the image.
determined by the position on the z-axis of the center of the image.
Brick Settings
This effect creates a rectangular parallelepiped from 3 successive channels.
For an illustration, see “Global Effects” in Chapter 1 (Volume 1).
Applying the Brick effect
Use the following procedure.
1
In the Global Effect>Ch1 - Ch4 menu, select HF2 ‘Brick.’
The Brick menu appears.
2
Press [Brick], turning it on.
The Brick effect is enabled, and a rectangular parallelepiped (brick)
showing the images of three channels appears. You can use the knobs to
adjust parameters for the height of the brick and the overlap between the
three images.
showing the images of three channels appears. You can use the knobs to
adjust parameters for the height of the brick and the overlap between the
three images.
Note
When the Brick effect is enabled, the z-axis position of the front image in
the source coordinate frame is shifted by the amount of half the height.
Therefore, the image is somewhat magnified.
the source coordinate frame is shifted by the amount of half the height.
Therefore, the image is somewhat magnified.
3
Set the parameters.
a) Setting for SD 4:3, SD 16:9
b) Setting for HD 4:3, HD 16:9
b) Setting for HD 4:3, HD 16:9
Knob
Parameter Adjustment
Setting
values
1
Height
Height of brick
0.00 to 8.00
a)
0.00 to 32.00
b)
2
Front Overlap
Front overlap
−
100.00 to +100.00
3
Side H Overlap
Side H overlap
−
100.00 to +100.00
4
Side V Overlap
Side V overlap
−
100.00 to +100.00