Справочник Пользователя для Harbor Freight Tools 47894

Refer to figure 1.

Uses 2 “AA” batteries (not included).  Open the Battery Compartment Cover (#8) and install the
batteries.  Close the Battery Compartment Cover (#8).

1.                              REMEMBER, IF YOU ARE NOT IN A DARK AREA, DO NOT REMOVE
THE LENS CAP.
2.  Check the scope operation by pushing the Power Button (#2), depressing it for 2 to 3 seconds.  Look-
ing through the Eyepiece (#1), you should see a green glow if the scope is working properly.
3.  In a near dark environment, remove the lens cap from the Objective Lens (#5) and push the Power
Button (#2). You will see the green glow.  Focus the Eyepiece (#1) and the Objective Lens Ring (#4) to
improve the clarity of view.
When the green glow fades, push the Power Button (#2) again to refresh the green glow.
!! Replace the Lens Cap Immediately when you are done!!

Operation With Illuminator

When operating in total darkness use the built in Illuminator (#6).
1.  Remove the lens cap and depress the Power Button (#2), so that the green glow appears.
2.  Depress and hold the Illuminator Button (#3) to turn on the Illuminator.
3.  When finished using the Illuminator, take finger off the Illuminator Button (#3) and the Illuminator will shut
off.  The green image of the Night Vision scope will slowly fade away.
4.  !! Replace Lens Cap Immediately!!

# 47894

3

Objective Lens (#5)

Illuminator (#6)

Power Button
(#2)

Illuminator
Button (#3)

Eyepiece
(#1)

Objective Lens Ring (#4)

Battery Compartment (#8)
(opposite side)

(lens cap
not shown)