Инструкции Пользователя для Yamaha SPX2000

   77

These are sampling effects that let you record the input signal and play it back.

This allows up to 2970.5 ms of recording (sampling). You can freeze the recorded data, repeat it as many times as desired, or 
modify the pitch.
Each aspect of the sound is controlled by the following effect parameters.

 REC MODE, REC DLY, RECORD

 PLAY, PLY MODE, START, END, LOOP, LOOP NUM

 PITCH, FINE

 MIDI TRG, TRG LVL, TRG MASK

 OUT LVL, MIX BAL.

■Basic parameters

Freeze

PRESET

1 IN/2 OUT

Freeze A

CLASSIC

Freeze B

REC MODE

MANUAL, AUTO

Recording method. Choose MANUAL (manual) or AUTO (automatic).

REC DLY

–1000—+1000 ms

Delay from when recording is triggered until recording actually begins.

RECORD

---

When REC MODE is MANUAL, press the [

▼ DEC] button (G) to enter record-ready mode; then 

press the [

▲ INC] button (G) to begin recording.

PLAY

---

Press the [

▲ INC]/[▼ DEC] buttons (G) to play back as specified by the PLY MODE setting.

PLY MODE

MOMENT, CONTI., INPUT

This is the method by which the sampled data will be played back.
MOMENT: Playback will continue while you hold down the [

▲ INC]/[▼ DEC] button (G).

CONTI.: Playback will begin when you press the [

▲ INC]/[▼ DEC] button (G), and will con-

tinue for the number of times specified by LOOP NUM. If you press the [

▲ INC]/[▼ DEC] button 

during playback, playback will start again from the beginning.
INPUT: Playback will begin when the input signal level exceeds TRG LVL, and will continue for the 
number of times specified by LOOP NUM. If a signal exceeding the TRG LVL is input again during 
playback, playback will start again from the beginning.

START

*a

*a. At 44.1 kHz or 88.2 kHz, this will be 0.0—2970.5 ms. At 48 kHz or 96 kHz, this will be 0.0—2729.2 ms.

Playback start point for the sampled data.

END

*a

Playback end point for the sampled data.

LOOP

*a

Playback start point when loop playback is used. If you use loop playback, the first pass will play the 
START—END region, and the second and subsequent passes will play the LOOP—END region.

LOOP NUM

0—100

Number of times the loop will play. Once the START—END region has played, the LOOP—END 
region will play the number of times specified here.

PITCH

–12—+12

Amount of pitch change for the playback, in units of one semitone. Positive (+) settings will make 
the playback pitch higher than the original pitch, and negative (–) settings will lower it.

MIDI TRG

OFF, C 1—C 6, ALL

MIDI trigger setting. When the SPX2000 receives a MIDI note-on message whose note number 
matches this value, it will play back the sampled data. If this setting is OFF, MIDI note-on messages 
will not be received. If this is ALL, any note-on message of C1 or higher will trigger playback.

TRG LVL

–60—0 dB

The level that will trigger recording/playback. If REC MODE is AUTO and the SPX2000 is in 
record-ready mode, recording of the input signal will begin when the input signal exceeds this 
level. If PLY MODE is INPUT, playback will begin when the input signal exceeds this level.