Руководство По Работе для Zeiss Axiovert 100

3D Microscopy
Axiovert 100/135/135 M

Monitor version

B  40-022-4  e    09/98

25

 

 

1

Monitor

2

Bracket

3

Monitor shutter

 

 

1

Loop-through input for video printer/video recorder

2

Socket for camera cable

3

Socket for video printer/video recorder

4

Output for monitor with Y/C input

5

Output for monitor with (F)BAS video input

6

Socket for 3D-CONTROL DAS-3 trigger

7

Socket for 3D illumination shutter

 Set up the microscope in accordance with

the operating instructions for the
Axiovert 100/135/135 M

 Equip the microscope with LD condenser

0.55 Ph1, Ph2, Ph3, DIC, DIC

 Use Velcro tape to stick the bracket to the

monitor housing

 Insert monitor shutter in the bracket in such

a way that the connector sockets are
positioned on the bottom right

 Before connecting the components for the
monitor version, make absolutely sure to note
the following:

 First read the enclosed manual from Kappa

entitled "Color TV Camera for Microscopy
and 3D Images";
chapter 5, "Safety regulations", should be
observed in particular.

 Cable connections may only be made if the

various components are switched off.

 It is important to use only the connectors

listed in the operating instructions of the
camera system

 Make sure that the cables are not bent or

laid out in too narrow a radius.

 Set up the video equipment with monitor

shutter and make the electrical connections.
Fig. 9/Fig. 11

8

External triggering of the Freeze function

9

Cold instrument socket /fuse holder

 10

INTERN:  standard setting
EXTERN: if video printer/video recorder are 
connected

 11

Output for monitor with RGB input

 12

Connector for monitor shutter