Руководство По Работе для Zeiss Axiovert 100

3D Microscopy

Notes on unpacking, transport and storage

B  40-022-4  e    07/98

5

The components for 3D microscopy must be
transported in their original packaging. It is
recommended to use the original packaging
also for storage.

The transport and storage temperatures must
comply with those listed under "Technical
Data".

When unpacking the components which are
equipped with polarizing foil (3D illumination
shutter, eyepieces with 3D shutter), make sure
to be particularly careful, since the foil can be
easily scratched.

 The components for 3D microscopy can

only be used with halogen lamps up to
max. 100 W.

 The power plug must be inserted in a

socket featuring a grounding (earth)
contact.
The grounding effect must not be reduced
by an extension cable which does not have
a protective ground wire.

 Prior to connection to the line, check

whether the voltage set on the selector at
the rear of the 3D-CONTROL DAS-3 unit
complies with the line voltage; it may be
necessary to change from 230 V to 115 V.
The change to 115 is only required for the
3D-CONTROL DSA-3 unit.
For further details, see "Care and
Maintenance" on page VIII.

 Cable connections may only be made if the

various components are switched off.

 For the video components from KAPPA, it is

absolutely necessary to use only the
connectors listed in the manual "Color TV
camera for microscopy and 3D images".

 Make sure that the cables are not bent or

laid out in too narrow a radius.

 The optical components must be protected

from dirt and mechanical damage;
special care must be taken to prevent the
polarizing foils of the 3D illumination
shutter from being touched.

 The components for 3D microscopy must be

protected from impact and humidity.

 To enable 3D microscopy to function

perfectly, it is necessary to use only
components and spares marketed or
admitted by us. When in doubt, please
contact our service staff.

 With the exception of the work described in

the "Care and maintenance" chapter, the
user must not perform any repairs or
changes himself. We would like to
emphasize that all other changes and
repairs must be performed by specially
authorized personnel.

 The manufacturer is not liable for damage

caused by unauthorized operation.  This
forfeits all the claims against warranty.